Jump to content

Tracy224

Recommended Posts

I installed a DJM 3-5 loading kit, axel flip notched frame ect.

2005 Silverado standard cab long bed.

All is well with the parts and install my problem is I have a vibration under excelleration that starts about 55-60 mph. Just cruzing at hwy speed you don't feel it until you accelerate or an incline in the road. I have the drive yoke from the tranny and rear end yoke at the same degree, parrel with each other. Every pic I see about pinion angle shows them parrel. But it also shows the drive running "down" hill to rear ended. My drive shaft I guess because of the flip kit and 5 inch drop now my drive shaft is going up hill to rear end. Any suggestions? I would like a degree or something presice to do and not like some have told me. " just move it till it stops"! I'm very close just wore out on trying to figure it out.

Thanks

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...