TheBryan35 0 Report post Posted December 17, 2020 I cut pin 7 it slowed the flash down I only had Rear LEDs when i switched the fronts to LED it would not flash at all, just one click and no ilumination, when i switch the front back to incandecent bulbs everything works fine again, i also tried flipping,the led around and,no change any ideas, also what does the u60438 pin in the picture do? do i need to cut that too? Quote Share this post Link to post Share on other sites
someotherguy 43 Report post Posted December 17, 2020 U60438 is the part # to the chip itself, not indicating any leg of it to cut. The only one you wanted to cut was the #7 pin that you already did. Weird symptom.. what if you swap the arrangement around? Incandescent out back, LED up front? I guess the only thing I would really caution you against here is not to remove/reinstall the LED's too many times as a lot of them seem kind of weak where the leads go up into the assembly, that's where I've seen more than a few break off. Are you 100% sure you got the correct part # on the LED's.. should be 3057/3157 style (dual function) front and rear. Richard Quote Share this post Link to post Share on other sites
