Jump to content
Sign in to follow this  
RevolutionRaceWorks

Headers need a sticky thread.

Recommended Posts

I've only had the dynatechs but so far so good. The install wasn't bad at all as this was my first major DIY install. They fit good and I didn't run into any problems with how they fit. I've got the old design. The new design got rid of the crazy driver-side header bend. I would recommend this to anybody as they are a direct bolt on header and can be installed by most people. Cost is a little high but wait for a GP buy and the price will be a lot better. I would say I noticed the gains at the mid RPM level. Good mod :thumbs:

What size are your primaries?

Share this post


Link to post
Share on other sites

2 years after the fact...

I guess someone replaced my trucks cats with a 2-1 Y pipe. I know because I ordered a magnaflow cat back, with the 2-muffler fitting and it won't work with what's there. Now I've got to get a replacement mid-pipe, and might as well do headers at the same time. Looking at dynatech 715-84110 and 715-84230 (headers and mid-pipe, respectively).

Anything I should know about this setup before I throw $1200 at it?

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...