-
Posts
26 -
Joined
-
Last visited
About allscrewedup
- Birthday 08/26/1964
Contact Methods
-
Website URL
http://
-
Skype
Richard
-
ICQ
0
Previous Fields
-
Owns
TBSS
-
Silverado SS/VHO/TrailBlazerSS Color
Silverstone
-
SS/VHO/TrailBlazerSS Year
2007
-
Drivetrain Config
2WD
-
Delivering Dealership
not a good one.
-
Build Date/TPW
04/2007
-
Modifications
stock
-
Delivery Date
sept.2008
Profile Information
-
Gender
Male
-
Location
Ma.
-
Interests
going fast 1/4 mile at a time. and wasting money.oh plus snowmobiling.
allscrewedup's Achievements
SS Member (2/5)
0
Reputation
-
Lebanon Valley Dragway - 6Th Annual - 2011
allscrewedup replied to Stitches040's topic in Events, Gatherings, & Rallys
Always fun time flies by. -
Rust build up under the ABS. sensor on the front hubs. cause is a increase in air gap.
-
45 years old here
-
Hi my job position is shop forman for a local GM dealer. And 24 years and counting.
-
Just my two cents but I have removed busted bolts in that spot at least a dozen times. You dont have to pull the head .Best bet is to get a right angle drill and buy a short drill bit. And get in there by removing the splash shield. Also heat the broken bolt with a small brazing torch tip. Let cool a bit and remove with EZ-out heating it softens the factory lock tite on the bolt. hope this helps you
-
NICE !!!!!!!!!!!!!!!!!!
-
If you are just changing the module it's self it can be removed buy it's self by removing the torx screws at the top. just use a short torx bit and a 1/4 inch wrench to turn the bit to brake the screws loose and lift the module up and off the abs trac unit.
-
Nice build up !!! See you next year at L.V.Dragway It should realy haul A$$.
-
Five-o-motorsports one set of eight. plus paid way to much.
-
Coil Resistance: 12.5 Ohms / High Impedance / High-Z (No ECM driver modifications required) * Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 60 lb/hr = 630 cc/min = 453 g/min * Static Flow Rate @ 87PSI ( 600kPa ) w/Gas: 85.7 lb/hr = 900 cc/min = 648 g/min * Gain: 0.11ms/mg * Offset: 0.055ms * Turn on time @ 14VDC: 1.14ms * Turn off time: 0.85ms @ 600KPa * Connector: Bosch EV1 * Orifice Type: Multi-orifice * Spray Pattern: 30 Degree Spray Cone * Factory fitted with Viton upper and lower o-rings Ok jury out on that. 4% max. in general
-
From what I understand is that all injectors that leave the manufacturer are within 2%
-
Oh well I did not sell the injectors on ebay. I guess it maybe a bad time of year with Christmas right around the corner and all so I am listing them here for $325.00 including shipping. Don't forget these are brand new and a set of (8). Thanks and if you are interested please send me a PM.
-
Hey every one I have listed the injectors in ebay item number 290365822762 good luck bidding.