Time2Kill

Where were all you guys when I had one for sale earlier this month?? I hope BSER keeps making them, they're a great looking roll pan when installed!

I can take credit card if that helps To the top!

to the top

to the top!

to the top!

I'll do $500 for a frame. Don't have the 36K one anymore. I'll do $1,250 for the frame with the 4 link (from KP Components, brand new, sells for $719 alone) and a rear axle already setup for it. I also have brand new QA1 coil overs I'll throw in for another $200

I've never fitted a used one to another SS so I don't know and I don't have another SS that I can try it on either. They had to be fitted when received new from BSER.

Finally decided to let this go. There is a small notch on the bottom edge that is missing and a small paint chip on the top edge, but otherwise in great shape. SOLD!!!!

I have some frames, also have a sand blasted frame with a 4 link rear suspension setup. I'm about 45 min north of Detroit. Let me know

I've got a TVS1900, complete kit except fuel pump, only 4,500 miles. $4,500 + shipping

Short answer, no Long answer, yes if you swap the tail shaft housing and output shaft, not a feasible option for most people.

Matt I have a couple of 4WD 4L65E transmissions Shoot me your zip code and I will get you some prices shipped.

I have a full kit minus the driver doors and driver rocker. The rest of the pieces have brackets/hardware with them. Everything is black. Let me know Tim

If you get one off ebay, just make sure it's the correct part # and not damaged. As said above, I have them for $160 shipped. I have sold quite a few of them on here.

I have a few of them available. $160 shipped. They came from trucks with steering wheel/DIC controls. The base clockspring doesn't work with radio controls.

The car was hit in the rear quarter/trunk.

This LS2 Engine & T-56 Manual Transmission dropout were removed from a 2006 Pontiac GTO with only 62,553 miles. This dropout is the most complete that you will find. It includes the engine, T56 6 Speed transmission, all accessories (Powersteering pump, waterpump, alternator, A/C compressor), starter, wiring harness with no cut wires, PCM, mass air flow sensor, and exhaust manifolds. This 6.0L LS2 combo will put out over 400hp/tq. This is an excellent swap for any street rod and includes everything needed to complete it. The vehicle it was removed from ran and drove before the motor was pulled. The engine ran great with no odd noises and no knocking. The transmission shifted flawlessly and went in and out of each gear smoothly with no grinding. The clutch also held with no slipping. The engine is available for local pickup in Romeo, MI. I can also ship the engine via freight. If you need a freight quote, I need the following info: Zip Code, Residential or Business delivery, and if a forklift is available. Price: $6,195 + freight

I've got the clockspring as well. Will send you a PM

I've got a ton of the stuff you are looking for except the ISS wing and bumper grille. Sending you a PM

They could at least post it it the right forum....

I have a original set of Silver Silverado SS wheels. No curb rash and good tires. I'd probably rate the wheels about a 9.8 out of 10.

Sent you a PM with a couple of options.

Yea, I actually have quite a few at the moment

I have LQ4 and LQ9 engines ready to go. Shooting you a PM

WINNER!!! Found some old pics of his truck and the exhaust matches. Can't imagine many trucks with trans cooler brackets and side exhaust.