psualumni

Yes. Guy at the exhaust shop that fabricated my exhaust cut the pipe just behind the muffler so I could fit it in my bed to take it home. Sent from my HTC One using Tapatalk

Exhaust System: I think that $500.00 plus buyer paid shipping is fair. If your seriously interested just let me know and Ill take it to UPS for a shipping quote. I have a feeling that it's going to be a PITA as I have never shipping anything this big before. I just looked on gmpartsdirect.com and this exhaust has been discontinued? Cheapest after market cat back on Summit is $600.00.

I think $100.00 plus buyer paid shipping is fair for the stock intake setup plus K&N filter. Ill do my best to keep shipping costs low my using UPS ground and making a box myself.

Bloomsburg, PA 17815 Ill post pictures of the exhaust system (cat back factory) within 24 hours.

I replaced the exhaust system on my 2004 SSS headers back, and the factory intake with a K&N. I have all the original parts, exhaust manifolds, mid pipes w/ cats, factory cat back exhaust and factory intake with a drop in K&N filter. All of these were taken off the truck at 20K.+/- If your interested in any of the parts, shoot me a PM or leave a note. Sorry no pictures of the stock cat back system.

Sold Locally! Sent from my HTC One using Tapatalk

Bump. Ditto for NoMoreSS.

This exhaust is LOUD when the engine goes under load, and calms down quite a bit when cursing along, has a nice mean sounding idle with the stock cam. The exhaust that I had made in place of this is on the quieter side as my wife complained about too much noise in the cab when the engine was under load. Then again, I have Dynamaxx long tube headers and no cats. I didn't notice drone in the cab as is was more just the roar of a short open exhaust, which I should have expected.

Greetings and salutations fellow SSS enthusiasts. I am attempting to sell my custom cat-back exhaust system featuring a Dynomax duel in duel out internal X pipe muffler and Vibrant resonators. This system was made by Performance Exhaust Maryland of mandrel bent stainless steel with polished slash cut tips. I had the system fabricated to attach to the mid-pipes approximately six inches forward of where the stock mid-pipe flange ended with duel lap joint band clamps, so some minor modification of the stock mid-pipes is required. I removed this system from my SSS because I had a second made with different mufflers and resonators. Total I have over $650 invested, I think that $500 shipped-to-you is a good deal considering the system has less than 200 miles. Send me a PM if you are interested and/or have any questions. I frequent this site with Taptalk so I will reply promptly.