dizl05

So I parked my truck for about a week and a 1/2. Went to get in it and drive and nothing. No Chime, No lights, Nothing! So naturally i thought bad batt. Batt is good had it checked. Terminals are clean its a new Red Top. Connections are good just did Big 3 couple of months ago. also checked all of the grounds on the big 3 just to make sure. Fuses are good, did a relay swap and that didn't do anything. I am now completely stumped. Any advise?

Congrats!

Just did headers and exhaust on my 05. did a ton of research and ended up doing dynamaxxx 1 7/8 LTs into Borla Hi Flo Cats 3" into Borla Muffs single in single out duals in front of passenger side tire. Got a deal on the Borla components wasn't really about the brand. Cheaper than a Corsa Sport. Sounds cool little different than most. If i could do it over i woulda went dumped with a dual in dual or single out muff. Cant tell you on gains cause i did a lot of stuff at once. heads, cam, 160 stat etc… tune is a must. wish i had a sound chip but I'm still working on her. pics and clips to come. Good Luck with your build!! keep us posted.

Nice! I've always liked the silver! black ss badges would look killer on that thing man.

Yea my truck is no where near ready for that. remember seeing on there that some guys met up there a few years back. i think one of them ran it but can't remember who.

Anybody running or going to the TX Mile this year? https://www.texasmile.net

Nice buy bro. Good starter! that Syclone is crazy man!!! what are you putting down with sucker?

Need at least a 3200 stall 3600 would be best tho. Anybody got one or now where to get one cheap?

Right on. Thanks for the reply man. Think I'm gonna get all the details on the trans and then get ahold of him.

Yea thats from a straight launch at full throttle. Its not shifting to 4th when i run it hard. regular driving it goes through the gears but still acts funny sometimes. Local guy in El Paso. He's got a pretty legit shop does some good stuff but Ive had nothing but bad luck with my build. Trans had to be rebuilt twice. So naturally i figured that was the problem also thought it might be the tune as well. He said he drove it several times and "it drives nice and has some good power" Big Bear Performance is coming to Houston which is a hike but i think it might be worth it. Either that or zippy. Put down 405 on the dyno, doesn't matter much if it aint hittin right tho. Still think i need to take a better look at the trans. Going to get the contact info of the trans builder and go straight to him, which i shoulda done in the first place. lesson learned. oh yea and they scuffed the crap outta my bumper, he's making that right tho. btw i really appreciate the help bro!

So after doing some test runs today... shifts 1-2 at about 5500 rpm 2-3 same about 5500 then it drops to 2500 rpm it climbs to around 3k and pretty much holds there when I'm driving it regular it continues shifting but when i get on it this is what it does. As I mentioned the guy who did my heads/ cam outsourced the trans. So I'm not 100% sure what all he did. He's supposed to be getting me the info. my guess is either the cam and stall aren't the best set up or the tune is off. the cam is a 231/234 torquer v4 which is not on the extensive write up zippy did on here.

So I finally got to do some mods to my SSS after years and this was the outcome... 2005 SSS MODS include Precision Race Components Heads from TX Speed Torquer v4 Comp Cam DBL Roller Timing Chain HV Oil Pump new plugs and wires 160 thermo k&n CAI custom tune 4l60 Trans Rebuild 3200 stall shift kit Dynamaxxx LT Headers Borla HF Cats Borla Muffs xpipe So heres the problem truck makes good power until it shifts from 3-4 gear and it just drops off. The dyno looked good as far as I saw. I had a shop do the build he out sourced the trans which i did not like but he assured me it would be good. The shop i took my truck to is pretty good so i trusted them. After driving it and researching the last few days I think it may be the servos in the trans. Any help would be much appreciated!

You still got your center console up for grabs?

Got a pick of these baby's mounted?

Cargo net and mats still up for grabs?

Still for sale?

WOW Thats freakin ugly, They need shot!! Not only is the size horrible the rims sux as well. Id rather have stock any day. The black & blue concept could be cool if you balance it out. black grille, emblems, ducts, tint etc. Not to much just enough to make it flow.

Lookin for a grey cc for my 05. It came with out one but I wanna replace the middle seat or jump seat and install the cc with some mods. Shipping would be to GA or I could pick up if close.

Yeah I was planning on gettin the whole piece. Thanks for the info bro. Ill make sure to hit ya up if I got any problems. Haha. Now to find a cc for sale.

check the post about the 2 SSS parting out. theres a blue one and a black one on there man.

I wanna install a cc and mod it with an Ipad hook up instead of modn the dash. just tryin to find out if the cc will go in fairly easy cause ill be doin enough work tryin to get the pad in.

So it would I be able to put one in mine if it came without one?

I have a 05 SS it doesnt have the center console that goes all the way to the dash. If I get a center Console will I be able to install it in my truck with out alot of headache? Looks like it wouldnt be to bad but I dont know Ive never looked colse at anyones.

I'm originally from beckley but I'm in the army now. Check out the pigeon forge meet. Sounds fun, I'm gonna try and make it.